Divine Project by Kristen Robinson

Market List:

• Picture Frame Bezel - Rue Romantique by Kristen Robinson
• Photo Clip Art - Flip Book Rue Romantique by Kristen Robinson
• Bezel Template - Rue Romantique by Kristen Robinson
• ICE Resin
• Craft Mat or Other Non Stick Surface
• Rhinestone Chain - Rue Romantique by Kristen Robinson
• 22 Gauge Silver Wire
• Round Nose Pliers
• Craft Stick
• Adhesive
• Measuring Cup
• 4 Coin Pearls - Manon Studio Mix
• 8 8mm Grey Pearls - Claire Studio Mix
• 2 6mm Grey Pearls - Claire Studio Mix
• 4 8mm Rhinestone Rondelles
• Silver Chain
• Silver Clasp
• 10 mm Jump Ring
• Wire Cutters

Directions:

1. Cut Photo from clip art section of flip book.
2. Using bezel template trace oval onto photo. Cut with scissors.
3. Adhere paper to back of bezel with paper safe adhesive.
4. Cut rhinestone strand to fit into interior of bezel. Place a small amount of adhesive onto back of rhinestone chain and adhere to top of photo.
5. Mix resin according to provided instructions. Place Bezel onto craft mat and pour resin. Allow to dry for at least 6 hours.
6. Cut 4" of silver wire. With round nose pliers create a loop 1½" from the end of the wire. Place the loop through the top bale of the bezel. Wrap the remaining wire around the top of the loop to close. Trim any excess wire.
7. Onto remaining wire place one 10mm coin pearl. Create a second loop and wrap closed.
8. Cut 6" of silver wire. With round nose pliers create loop 2" from the end of the wire, and place through the top loop of the first coin pearl link. Wrap the remaining wire closed and trim excess. Onto the long end of the wire place one 8mm grey pearl, one 8mm rhinestone rondelle, and one 8mm grey pearl. Create a loop with round nose pliers. Wrap remaining wire around loop to close.
9. Repeat step 7-8 Leaving the final top loop open.
10. To the top loop of the last grey pearl link attach 2 strands of silver chain measuring 3" each. Wrap the remaining wire around the loop and close.
11. Cut 4" of silver wire. With round nose pliers create a loop 1½" from the end of the wire. Place the loop through the last link(s) of the two strands of silver chain. Wrap the remaining wire around the top of the loop to close. Trim any excess wire.
12. Create a second loop on the adjacent end and place clasp ring through the loop. Wrap remaining wire.
13. Repeat steps 6-12 on the adjacent side, replacing the 10mm jump ring for the silver clasp.

You will also ? these publications: